FAQ
FAQ

Home/Resources/FAQ
FAQ
Q:Do children's recreational boats (such as small boats on park lakes) need navigation lights?
A:

Yes, and special safety requirements apply: ① For night operation, low-brightness, touch-safe LED navigation lights must be fitted (red port, green starboard, white stern) to avoid strong light hurting children's eyes; ② The lights must have an anti-detachment design (such as a reinforced clip) to prevent children from knocking them off; ③ If operation is limited to enclosed waters (such as a small lake), battery-powered portable combination lights may be used so that staff can clearly identify the position of each boat.

Q:What should be noted when navigation lights are used together with the vessel's radar?
A:

① The navigation lights must be installed away from areas shadowed by the radar antenna so that the radar detection range is not affected; ② When a high-power searchlight is switched on, it must not shine directly at the radar antenna (this may interfere with radar signal reception); ③ In low visibility, navigation lights, signal lights and the radar transponder must all be switched on, giving a second means of identifying the vessel.

Q:Do brightness requirements for navigation lights differ by vessel tonnage?
A:

Yes: ① For vessels of 1000 GT and above, navigation lights must have a visibility of at least 5 nautical miles and signal lights at least 3 nautical miles; ② For vessels of 20-1000 GT, navigation lights must have a visibility of at least 3 nautical miles and signal lights at least 2 nautical miles; ③ For vessels under 20 GT, navigation lights must have a visibility of at least 2 nautical miles and signal lights at least 1 nautical mile, in accordance with the COLREGs visibility categories for the vessel's tonnage.

Q:If a marine light fails temporarily and cannot be repaired in time, is there an emergency alternative?
A:

There is an emergency plan: ① A portable LED navigation light that meets maritime standards (waterproof and drop-resistant) may be used as a temporary substitute, and its mounting position must meet the installation requirements of the original navigation light; ② During emergency night navigation, an additional handheld flashing light (flashing once every 30 seconds) must be switched on to alert nearby vessels; ③ Once the fault is repaired, the official navigation light must be reinstalled immediately; temporary lights must not be used long term.

Q:Do decorative lights on a yacht conflict with the navigation lights, and how should they be used correctly?
A:

They do not conflict, but they must be used correctly: (1) Decorative lights (such as light strips and accent lights) should use low-brightness, non-penetrating light sources so that they do not interfere with the navigation light signals; (2) Strong decorative lights that obstruct visibility (such as spotlights aimed at the wheelhouse) must be switched off while underway; (3) Decorative lights must not use red, green or white, the three colors reserved for navigation lights, to prevent confusion with navigation signals.

Q:Are there requirements for the light color purity of marine lights, and does it affect navigational safety?
A:

Yes, there are clear purity requirements: (1) Red light must have a wavelength of 620-750nm, green light 495-570nm, and white light a color temperature of 5000-6500K, and the light must pass spectral testing and certification; (2) Impure light color (for example a red light that leans orange or a green light that leans yellow) can cause other vessels to misread the signal and increases the risk of collision, so non-compliant marine lights must not be used.

Q:Which vessels are solar marine lights suitable for, and what should be noted?
A:

(1) Applications: small vessels (such as fishing boats and aquaculture boats), auxiliary lighting for moored vessels, or boats without a stable power supply; (2) Notes: install in an unobstructed area on deck (to ensure average daily sunlight of ≥4 hours); choose monocrystalline silicon solar panels with a conversion efficiency of ≥18%; fit a storage battery (endurance ≥72 hours in overcast weather) to avoid power loss at night.

Q:Are there special requirements for marine lights in low-temperature environments (such as polar voyages)?
A:

The lights must be suited to low-temperature environments: (1) Choose low-temperature-resistant lights (operating temperature range -40℃~+60℃) to prevent ice build-up on the lens and cracking of the housing; (2) Fit the power system with low-temperature insulation to prevent loss of battery capacity; (3) Regularly remove ice from the lens surface (a dedicated de-icing agent may be used) so that brightness and beam range are not affected.

Q:Are there explicit standards for the beam angles of marine lights?
A:

Yes, strict standards apply (in line with COLREGs): (1) Red sidelight: beam angle 112.5° from the bow toward port; (2) Green sidelight: beam angle 112.5° from the bow toward starboard; (3) White sternlight: beam angle 135° aft from the stern; (4) All-round lights (anchor light, warning light): beam angle 360°, ensuring all-round visibility.

Q:Are there special requirements for marine lights when a fishing vessel is engaged in fishing operations?
A:

Yes, there are special requirements: (1) During operations, an all-round yellow light must be switched on (visibility distance ≥2 nautical miles) to tell passing vessels that "fishing operations are in progress and a safe distance must be kept"; (2) Trawlers must fit additional working indicator lights (red flashing lights) at the bow and stern to mark the trawl area; (3) When hauling the net at night, a searchlight must be used to illuminate the working area, but it must not be aimed directly at the wheelhouse of other vessels.

Q:Do marine lights need periodic inspection and certification?
A:

Yes. During the annual vessel survey, the maritime authority checks whether the brightness, color, beam angle and waterproof performance of the marine lights meet the standards. A vessel that fails the inspection must rectify the issues before it can obtain its navigation permit, which safeguards navigational safety.

Q:What are the advantages of LED marine lights over traditional halogen marine lights?
A:

(1) Energy saving: power consumption is only 1/3-1/5 of a halogen light; (2) Long life: service life ≥50,000 hours (halogen lights last only 500-1000 hours); (3) Strong vibration resistance: no filament structure, so the light withstands the constant motion of a vessel; (4) Fast start: instant light with no warm-up and stable brightness.

Q:How do I quickly troubleshoot a navigation light that does not light up?
A:

Troubleshooting steps: (1) Check whether the power switch is on and whether the fuse has blown; (2) Test the voltage on the power cable to rule out a power supply fault; (3) Check whether the bulb / LED module is burnt out (replace it and test); (4) Check the wiring connectors for looseness or corrosion (clean or replace the connectors).

Q:Do small craft (such as kayaks and fishing boats) need navigation lights?
A:

Yes. When sailing at night / low visibility, small craft must carry at least: a red port light, a green starboard light (or a combined navigation light) and a white stern light. If the vessel is under 7 m in length, portable LED navigation lights may be used to ensure it is seen by other vessels.

Q:What do the red, green and white navigation lights signal?
A:

① Red light (port): indicates the vessel's port side; other vessels must pass on its starboard side; ② Green light (starboard): indicates the vessel's starboard side; other vessels must pass on its port side; ③ White light (stern light / anchor light): the stern light indicates directly astern of the vessel, and the anchor light indicates the vessel is at anchor.

Q:How is the waterproof performance of navigation lights ensured?
A:

Navigation lights are protected by a three-layer waterproof design: ① the lens uses tempered glass + a gasket seal; ② the housing is corrosion-resistant aluminum alloy / stainless steel with a waterproof coating on the surface; ③ wiring interfaces use waterproof connectors (such as M12 waterproof plugs) to prevent seawater ingress and internal short circuits.

Q:Is there a backup power supply for navigation lights?
A:

Compliant vessels are fitted with dual power backup: main power (vessel generator / battery) + emergency power (backup battery bank). If the main power fails, the emergency power switches over automatically to keep critical lights such as navigation lights and signal lights running, with a transfer time of ≤3 seconds.

Q:How should navigation lights be used when sailing in fog?
A:

In fog, switch on: ① the forward and aft anchor lights (white, visible distance ≥2 nautical miles); ② keep the sidelights on; ③ switch off high-intensity lights (to avoid glare affecting other vessels); ④ if the vessel is at anchor, additionally switch on an all-round red light to alert passing vessels to keep clear.

Q:Do brightness requirements for navigation lights vary by sailing area?
A:

Yes: coastal / ocean voyages require higher brightness (visible distance ≥3 nautical miles), while inland waterway / harbor navigation may use lower brightness (visible distance ≥1 nautical mile); in low-visibility weather such as fog, rain or snow, enhanced fog signal lights should be switched on, with brightness at least 30% higher than that of standard navigation lights.

Q:What should be considered when replacing navigation lights?
A:

① Match the vessel voltage (commonly 12V/24V DC); ② Choose products with marine certification (such as IEC certification); ③ Make sure the IP rating is ≥IP67 (resistant to immersion in waves); ④ After replacement, test the beam angle and brightness to avoid signal distortion.

Q:What maintenance interval is recommended for navigation lights?
A:

Routine maintenance every 1-3 months: clean dust and oil from the lens, check the brightness of the bulb / LED module, and tighten wiring connectors to prevent corrosion; the annual service should test waterproof performance and replace aged parts (such as seals and wiring) to ensure reliable operation in severe sea conditions.

Q:What standards must navigation lights on vessels on international voyages meet?
A:

They must comply with the Convention on the International Regulations for Preventing Collisions at Sea, 1972 (COLREGs) and the relevant technical standards of the IMO (International Maritime Organization). The brightness, color, beam angle and visible distance of the lights must be certified, and some vessel types must also comply with SOLAS Convention requirements.

Q:Are there requirements for the installation position of navigation lights on a vessel?
A:

There are strict requirements: the red port light is mounted on the port side of the bow, the green starboard light on the starboard side of the bow, both at the same horizontal height and not lower than the gunwale; the white stern light is mounted at the center of the stern, no lower than the sidelights, so that the vessel can be identified within 360° at night.

Q:What are the main types of marine lights?
A:

By function they can be divided into: navigation lights (red port light, green starboard light, white stern light), signal lights (such as anchor light, fog horn light and pilot light), searchlights / work lights (working illumination), and warning lights (alerts for special operating conditions).

Q:What is the core function of a marine light?
A:

A marine light has two core functions: first, to provide illumination during nighttime / low-visibility navigation and maintain the operating field of view for the vessel; second, to transmit navigation signals (such as heading, vessel type and operating status) to prevent collisions, in compliance with the International Regulations for Preventing Collisions at Sea (COLREGs).

If you have any questions, please contact Contact Us
Earning trust through quality, achieving shared success through service. We look forward to broader and deeper cooperation with you.